RemoteTx Manual
remotetx.net

Logging and loggers

The built-in log#

QSOs you log in the FT8 tab are kept in your browser, on this computer. Click Log in the top bar to see them; the badge shows how many there are.

The log

ControlWhat it does
Export ADIFDownloads the log as an ADIF file, for LoTW, QRZ, Club Log or your main logging program.
Clear logDeletes every QSO from this log. Export first.
✕ on a rowDeletes that QSO.

Stations in the log are marked B4 in Band Activity.

Logging a QSO. At the end of a QSO (or when you click Log QSO), the Log QSO form shows call, grid, reports sent and received, start and end time (UTC), frequency, mode and a comment. Check them and click Log it. With Log QSOs automatically on (in Sequencing), QSOs are logged without the form.

ℹ️Note

The log lives in this browser's storage. It isn't shared with other computers or browsers, and clearing the browser's site data removes it. Export ADIF regularly, or send QSOs to your main logger as below.

Sending decodes and QSOs to your logger (RTx EasyConnect)#

RTx EasyConnect is a small app for Windows and macOS that runs on the same computer as your browser. With it linked, programs such as HRD Logbook, GridTracker, Log4OM and N1MM Logger+ can receive decodes and QSOs in realtime.

DirectionWhat goes across
FT8 tab → loggerStatus (dial, mode, DX call and grid, report, Tx enabled / transmitting, Rx and Tx offsets), every decode, Clear, and each logged QSO (as WSJT-X QSO Logged and Logged ADIF).
Logger → FT8 tabReply (the logger's double-click calls that station), Halt Tx, Free Text (Tx5), Location (your grid), Highlight Callsign, Configure (mode, Rx offset, DX call and grid), Clear. Only when Accept UDP requests is ticked in EasyConnect.

Setting it up#

  1. Install and start RTx EasyConnect on the computer you're operating from.
  2. In RemoteTx, connect the radio on the Radio tab and click EC (next to VFO / PTT / CW). It turns red when linked.
  3. In EasyConnect, open the FT8 → loggers card and enter the same values as WSJT-X's Reporting tab: UDP Server 127.0.0.1 (or a multicast address such as 224.0.0.1), port 2237, instance name WSJT-X. Tick Accept UDP requests if the logger should be able to call stations.
  4. Optionally tick N1MM Logger+ Broadcasts to send each logged QSO as an ADIF record to 127.0.0.1:2333 (for HRD Logbook's QSO Forwarding → UDP Receive, or N1MM).
  5. On the FT8 tab, a green Logger chip appears in the top bar. Hover over it to see what's being sent and where.
⚠️Warning

Use either WSJT-X UDP or N1MM broadcasts into the same HRD log, not both, or every QSO is logged twice.

Logger off (amber chip) means EasyConnect is linked but both FT8 → logger paths are turned off in its settings.

For every setting, HRD Logbook on another PC, multicast, and Windows Firewall, see EasyConnect: FT8 to loggers.

© RemoteTx® · remotetx.net · Manual built 2026 · Updated 2026-11-19