RemoteTx Manual
remotetx.net

Radios guide

RemoteTx controls each supported transceiver through its own radio page in the client, built around that radio's controls. This section has a quick-start guide for each radio: what to set on the radio, how to connect it to the Raspberry Pi, and how to get on the air.

Radio guides#

More radios will be added to this section.

Supported radios#

ManufacturerRadio pages
IcomIC-7100, IC-7200, IC-7300, IC-7300 Scope, IC-7300 MK2 Scope, IC-7610, IC-7610 Scope, IC-705 Scope (HF only)
YaesuFT-710 Scope, FT-991 / FT-991A
ElecraftKX2, KX3, K3 / K3S
RotatorsYaesu rotators

The same three steps for every radio#

Whatever the radio, a session follows the same pattern in the client:

TabWhat you do
SetupChoose the radio, the USB port it's on, and its CAT baud rate.
RadioClick Connect … for your radio, power it on if needed, and operate.
AudioStart the station's audio and call the radio for two-way audio.

Each radio guide gives the exact values for that radio.

What works with every radio#

  • CW keyer: paddle CW via audio, using the USB-CW-VOX adapter on the radio's KEY jack.
  • FT8 / FT4: the FT8 tab switches TX/RX and sets the frequency through the radio page, for every radio type.
  • RTx EasyConnect: loggers and WSJT-X through the EC button, on the radio pages listed in Radio link.
© RemoteTx® · remotetx.net · Manual built 2026 · Updated 2026-11-19